| JustinL |
I'm trying to install my seatbelts with my new sparco seats and I need to have some 90° brackets made to do it "the right way".
Is someone willing to do this for a couple beers or should I go to a shop to have them made? It just needs to be a 3" X 3" flat piece of strong metal bent 90° 1" in from one side.
Thanks guys,
Justin |
|
|
| mr2_import |
| shit man that is soo easy to do if you hold off for a while i am a tin basher and i can make that for you in like 2 seconds I am in school right now and can't do it but if you wait till around april may i should be able to make them bad timing man lol |
|
|
| KAOS41 |
| RCI makes a harness mount kit....it bolts to the floor and your harness clips into it..Got mine at JB's for $35 |
|
|
| orangeteg |
| Check out Props by Kruse, Kustom Fabrication & Chassis works #(780)406-2580, 12825-52street. Look for Chris tell him orangeteg sent you, He'll hook you up. |
|
|
| 2003specv |
You could take some 2"x1/4" angle iron and cut one side down to the 1" height you need.
Go to Metal Supermarket, they'll probably want like $2 for 6" of 2"x1/4" angle iron. And I bet they would cut it down for you as well. They always offer to cut material when I'm there.
Angle iron will be much stonger than a bent piece of steel also. |
|
|
|
