| Need help PLEASE - Click HERE for Original Thread |
| Rx7 newbie |
Im instaling a clutch and found heat spots on my flywheel so i thought i should take it off and get it machined. So i took off the big nut 2 1/8 and thought that the flywheel would just side off but no its on there tight. Then i tried to use a pulley and that did not work cuz i kept snaping the bolts that held it in place. so i am about to give up on it and leave the hot spots alone. If anyone knows how to take the flywheel off please help me for i am going nuts:mad: thanks
Armand |
|
|
| Transporter |
| gently beat it with a mallet to loosen it |
|
|
| Rx7 newbie |
| yah man i tried that and it wont budge not a bit so im gona leave it on there because it's not comming off. whats the worst that could happen from the heat spotsif i leave it on ? |
|
|
|
|
|
Do you want to post a reply? This is the 780tuners.com archive, to participate in daily discussions on cars, visit our forums website and register today! Its free.
< Contact Us - 780Tuners Edmonton Car Forums - Advertising Info - Archive
>
Powered by: vBulletin Version 2.3.9
Hosted by: Beyond Car Forums
Sponsored by: Replicon's Web TimeSheet - timesheet software
for time tracking
Copyright ©2000 - 2008, Jelsoft Enterprises Limited.
