| bov help - Click HERE for Original Thread |
| truslide |
| so i got my self an hks ssqv and i tryed hookin it up and i cant get it to work can any one help right now iam running my silvia with sr20.... i stilll have my side mount for now so i hooked up the bov to the pluged hole right be side my inter cooler pipeing it has pressure and i t'ed in to the vac line that went to my stock one and nuttin i took the stock one out and plugged the lines that it was hooked up too and iam still gettin the the pressure realse noise that i was with the stock one now i think that my problem may be that iam not gettin the vac that that i need so iam gonna try and t it off right off from the line that gos right in to the throttle can any one help me out |
|
|
| Rich_A |
epic run-on sentence.
fucking epic. |
|
|
| anschutz_93 |
lmao... I will try to give you some help.
pluged hole right be side my inter cooler pipeing it has pressure
Your bov has to be on your intercooler piping :confused: You must have an appropriate flange to mount the hks bov...
That metal hose at the top back of the hks, run a vacuum line from that to a port on your throttle body. The base goes into the flange with an o-ring on the bottom and a clip to hold in place. I really don't see how could of installed it wrong... if it is blowing air it is done correctly. Rev the engine with your hand in front of the bov (if you have a recirculation tube take it off) it should blow a lot of air. |
|
|
| 30psi_on4banger |
| I know on my b.o.v there was different settings (screw to adjust), Maybe lower the spring tension so there is enough pressure to open it, |
|
|
| truslide |
| its mounted right like its set up right but not realseing the pressure |
|
|
| Nissan Fanboy |
| The SSQV doesn't need adjustment. It's a push-pull type valve. |
|
|
| Fazda |
| as long as it is in your IC, or you stock BPV, or BOV location you should have enough pressure to Blow Off. How much boost are u running? if it sounds weak maybe u aren't running enough boost. i know mine at 7psi was pretty quite but at 20psi it just screams! |
|
|
| truslide |
| iam 10 to 12 psi |
|
|
| anschutz_93 |
| DONT touch that bolt at the back... It will crack the diaphragm=bov junk. The hks is actually quite loud even without boost (rev'ing in neutral with the hood up you can hear it quite well). I'm running 13psi, recirculated and it can still be heard inside the cabin. |
|
|
|
|
|
