780tuners.com Edmonton Car Forums

Edmonton Car Forums > 780Tuners Edmonton Car Forums Archive > Edmonton and Area Car Forums > Club Zone- Visit here for several local clubs in Alberta > Edmonton RX7 Club

street porting - Click HERE for Original Thread

Cheemoney

how much horsepower does it add to stock? i tried searching but couldn't come up with any results in the forums. sorry if this has been asked already.

4kruzn

aprox 20hp. should take stock car from 160 to about 180hp. a street port with a header and good exhaust and a good intake system can often put down 180-190 at the wheels.

Cheemoney

i currently have a street ported S4 13b. with a free flow exhaust. i'm looking for one of those cone air intakes. i've been looking on ebay. what's the diff between HP and WHP? it has also been rebuilt recently if that makes a difference.

anschutz_93

WHP is actual power to wheels after drive train loss. It is what you would see if your car is on a dyno.
HP to most people means what the engine produces at the crank. WHP is accurate (but different dyno's record differently...), HP @ the crank isn't accurate unless you have had the engine tested outside the vehicle.

Cheemoney

are there any dynos in edmonton? how much do they charge to do a test run.

RotaryJunkie13B

quote:
Originally posted by 4kruzn
aprox 20hp. should take stock car from 160 to about 180hp. a street port with a header and good exhaust and a good intake system can often put down 180-190 at the wheels.

r u able to doo a street port with out rebuild?

4kruzn

sort of. the engine has to come completely apart to be ported so to do that and not do rebuild would be a huge waiste of time and money but i could be done.

porting while doing a full rebuild is about 400.00

porting with out would be about 2000+. and you would still not have a fresh engine.

RotaryJunkie13B

quote:
Originally posted by 4kruzn
sort of. the engine has to come completely apart to be ported so to do that and not do rebuild would be a huge waiste of time and money but i could be done.

porting while doing a full rebuild is about 400.00

porting with out would be about 2000+. and you would still not have a fresh engine.

guess no buddy bud deals from conroy.. awe.. haha

but ya looking to do a rebuild and street port this winter. how much you figure?

Do you want to post a reply? This is the 780tuners.com archive, to participate in daily discussions on cars, visit our forums website and register today! Its free.

< Contact Us - 780Tuners Edmonton Car Forums - Advertising Info - Archive >